Balboa-water-group Skimmer, Spa and Hot Tubs Manuel d'utilisateur télécharger pdf

SKIMMER INSTALLATION

SPA AND HOT TUB

1) Locate a ﬂat surface approximately 4”x 12” where the skimmer will mount ﬂush to the wall.

NOTE: The skimmer can be mounted over the tile if necessary to obtain a ﬂat surface.

2) Center the skimmer plate to the normal water line.

3) From the top of the skimmer, 8 1/2” down, mark a spot and drill a hole using a 2 1/2” hole saw for the

thru wall ﬁtting.

4) Install the skimmer thru wall ﬁtting with the gasket on the back or front using silicone as a seal, and secure

using the straight or 90° backing nut.

5) Holding the skimmer face plate in position, insert the skimmer grate thru the skimmer and thread it into the

thru wall ﬁtting hand tight.

6) Making sure the skimmer is properly positioned (straight up and down), drill a 5/32” diameter hole through

the wall using the hole at the top of the skimmer face plate as a guide.

7) Using a small amount of silicone on the hole and screw, insert the screw through the face and thread it into

the wall.

NOTE: USE MULTIPLE SUCTION OUTLETS. IF FITTING BREAKS, REPLACE IT.

88-4033 Rev B June 17, 2009

8 1/2

SKIMMER INSTALLATIONSPA AND HOT TUB1) Locate a ﬂat surface approximately 4”x 12” where the skimmer will mount ﬂush to the wall. NOTE: The skimmer c

Pas de commentaire

Balboa-water-group Skimmer, Spa and Hot Tubs Manuel d'utilisateur