Balboa-water-group ML400 - Mach 3 User Guide Manuel d'utilisateur

ML400 User Guide EL/GL Series - Mach 3YXcYfX$`ejkild\ekj%ZfdJets Aux Temp LightHeatJets Aux Temp LightNote regarding EL and GL systems: Mach 3 EL a

Page 8Jets 2 (optional on some systems)Press the “Jets 2” button once to turn pump 2 on or off, and to shift between low and high speeds if it is a tw

Page 9Basic Installation and Configuration Guidelines for Mach 3 EL-Series Spa Controllers.Use minimum 6AWG copper conductors only.Torque field connec

P/N 40570-99_C 04/26/2007Warning! Shock Hazard! No User Serviceable Parts.Do not attempt service of this control system. Contact your dealer or serv

EL/GL SERIES (Mach 3) CONTROL WITH ML400 PANELThe ML400 panel can be used as a main panel with the EL2000 and EL1000 systems, but only as a remote/add

Temp Set (80°F - 104°F / 26.0°C - 40.0°C)The last measured temperature is constantly displayed on the LCD. Your spa’s set temperature range may vary f

Light Some systems are equipped with both a spa light and a fiber optic light; however, only one can be accessed by this panel. (Larger panels may be

User PreferencesThere are several aspects of spa operation that you can customize using the User Preferences submenu.Press “Temp” then “Jets”, then “L

Page 5GFCI ProtectionYour spa may be equipped with a GFCI Protection feature. If your spa does have this feature enabled, the GFCI Trip Test must occu

Diagnostic MessagesMessage MeaningNo message on display.Power has been cut off to the spa.“Overheat” - The spa has shut down.1 On some systems, an ala

Diagnostic Messages (continued)Message MeaningTemperature unknown.Standby Mode has been activated by pressing a button combination on the user panel.T