Balboa-water-group ML900 - Mach 3 User Guide Manuel d'utilisateur

Jets 3 OptionJets 1 OptionInvertBlowerFiberJets 3 OptionTime Warm Jets 1 Jets 2 Jets 3 OptionCoolMode/Prog InvertBlowerFiber LightF2TLF1PLonnnnnnnF2FF

Page 8GFCI ProtectionYour spa may be equipped with a GFCI Protection feature. If your spa does have this feature enabled, the GFCI Trip Test must occu

BlowerJets 1Jets 1 Jets 2 LightLightBlowerJets 1Jets 1 Jets 2Jets 1 Jets 2Jets 1 Jets 2Jets 1Jets 1Jets 2Jets 2BlowerBlowerPage 9Jets 4 (optional o

P/N 40568-99_D 07/23/2008Warning! Shock Hazard! No User Serviceable Parts.Do not attempt service of this control system. Contact your dealer or serv

EL/GL SERIES (Mach 3) CONTROL WITH ML900 PANELThe ML900 panel can be used with the EL8000, EL5000, EL2000 and EL1000 systems. This user guide lists al

Temp Set (80°F - 104°F / 26.0°C - 40.0°C)The last measured temperature is constantly displayed on the LCD.Note that the last measured spa temperature

Jets 2 (optional on some systems)Press the “Jets 2” button once to turn pump 2 on or off, and to shift between low and high speeds if it is a two-sp

Light Some systems are equipped with both a spa light and a fiber optic light; however, only one can be accessed by this panel. (Larger panels may be

Page 5Ozone (optional)On most systems, the ozone generator (if installed) runs during filter cycles (except when pump 1 is operating at high speed on

Diagnostic MessagesMessage MeaningNo message on display. Power has been cut off to the spa. “Overheat” - The spa has shut down.1 On some systems, an

Diagnostic Messages (continued)Message MeaningWhen your spa is first actuated, it will go into Priming mode. orTemperature unknown. Temperature not c