Balboa-water-group Freedom Series Conversion Kit Manuel d'utilisateur télécharger pdf

STEP 1: Make sure spa pump is not running.

STEP 2: Remove existing components by pressing palm against front of jet and rotating 1/8 turn counter clockwise.

This will remove escutcheon (#5) or grill (#6) from wall ﬁtting. To remove retaining ring (#4) or bearing/nozzle

adapter (#7), place ends of needle nose pliers into notches and unthread, turning part counter clockwise.

NOTE: Hydro Air part number 10-5875 AF Mark II wrench can be used.

STEP 3: Making sure seat ring (#2) is still in place inside jet, insert eyeball (#3) into jet and thread in retaining ring (#4)

turning clockwise until snug against eyeball.

STEP 4: Place escutcheon (#5) on wall ﬁtting (#1) by lining up tabs on wall ﬁtting with slots on escutcheon. Press

escutcheon in towards spa and twist 1/8 turn clockwise until escutcheon locks into place.

NOTE: If using metal escutcheon (#8), leave off plastic twist lock escutcheon (#5) and press metal escutcheon into

wall ﬁtting (#1) until ﬂange touches wall ﬁtting.

88-FS00 Rev A June 24, 2009

PART NUMBER DESCRIPTION

For:

10-FS00TW Whirlpool Trim Kit

10-FS00TD Directional Trim Kit

10-FS00TA Adjustable Trim Kit

16-FS00TM Microssage Trim Kit

FREEDOM SERIES CONVERSION KIT INSTALLATION INSTRUCTIONS

STEP 1: Make sure spa pump is not running. STEP 2: Remove existing components by pressing palm against front of jet and rotating 1/8 turn counter clo

Pas de commentaire

Balboa-water-group Freedom Series Conversion Kit Manuel d'utilisateur