Balboa-water-group ML700 - Mach 3 User Guide Manuel d'utilisateur télécharger pdf (Page 12)

P/N 40520-99_C 04/26/2007

Warning! Shock Hazard! No User Serviceable Parts.

Do not attempt service of this control system. Contact your dealer or service organization for assistance. Follow

all owner’s manual power connection instructions. Installation must be performed by a licensed electrician and all

grounding connections must be properly installed.

Basic Installation and Configuration Guidelines for Mach 3

EL-Series Spa Controllers.

Use minimum 6AWG copper conductors only.

Torque field connections between 21 and 23 in lbs.

Readily accessible disconnecting means to be provided at

time of installation.

Permanently connected.

Connect only to a circuit protected by a Class A Ground Fault

Circuit Interrupter (GFCI) mounted at least 5’ (1.52M) from the

inside walls of the spa/hot tub and in line of sight from the

equipment compartment.

CSA enclosure: Type 2

Typical field connections

for main power.

Refer to Wiring Diagram

inside the cover of the

control enclosure.

Refer to Installation and

Safety Instructions provided

by the spa manufacturer.

Warning: People with infectious diseases should not use a

spa or hot tub.

Warning: To avoid injury, exercise care when entering or

exiting the spa or hot tub.

Warning: Do not use a spa or hot tub immediately following

strenuous exercise

Warning: Prolonged immersion in a spa or hot tub may be

injurious to your health

Caution: Maintain water chemistry in accordance with the

Manufacturers instructions.

Caution: The equipment and controls shall be located not

less than 1.5 meters horizontally from the spa or hot tub.

CSA Compliance/Conformité

Caution:

• Test the ground fault circuit interrupter before each use of

the spa.

• Read the instruction manual.

• Adequate drainage must be provided if the equipment is to

be installed in a pit.

• For use only within an enclosure rated CSA Enclosure 3.

• Connect only to a circuit protected by a Class A ground

fault circuit interrupter.

• To ensure continued protection against shock hazard, use

only identical replacement parts when servicing.

• Install a suitably rated suction guard to match the

maximum flow rate marked.

Warning:

• Water temperature in excess of 38°C may be injurious to

your health.

• Disconnect the electrical power before servicing.

Attention:

• Toujours verifier l’efficacite du disjoncteur differentiel avant

d’utiliser differentiel avant d’utiliser le bain.

• Lire la notice technique.

• Lorsque l’appareillage est installe dans une fosse, on doit

assurer un drainage adequat.

• Employer uniquement a l’interieur d’une cloture CSA

Enclosure 3.

• Connecter uniquement a un circuit protege par un

disjoncteur differentiel de Class A.

• Afin d’assurer une protection permanente contre le danger

de shock electrique, lors de l’entretien employer seulement

des pieces de rechange identiques.

• Les prises d’aspiration doivent etre equipees de grilles

convenant au debit maximal indique.

Avertissement:

• Des temperatures de l’eau superieures a 38°C peuvent

presenter un danger pour la sante.

• Deconnecter du circuit d’alimentation electrique

avante l’entretien.

Warning/Advertissement:

• Disconnect the electric power before servicing. Keep access

door closed.

• Deconnecter du circuit d’alimentation electrique avant

l’entretien. Garder la porte fermer.

GREEN

WHITE

WHITE AC (120 V)

FOR W-WIRES

RED AC (240 V)

FOR W-WIRES

BLACK

RED

FROM GFCI

J23 J19 J28

J43 J42 J48

J53 J54

J55 J25

J26

Warning! GFCI Protection.

The Owner should test and reset the GFCI on a regular

basis to verify its function.

Warning! Qualified technician required for service and installation.

1 2 ... 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire

Balboa-water-group ML700 - Mach 3 User Guide Manuel d'utilisateur Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Panneau de contrôle Balboa-water-group ML700 - Mach 3 User Guide