Balboa-water-group ML550 - Mach 3 User Guide Manuel d'utilisateur

YXcYfX$`ejkild\ekj%ZfdHeatCool Warm Jets 1 Jets 2 Blower Light ModeHeatCool Warm Jets 1 Jets 2 Blower Light Mode900854ML550 User Guide EL/GL Series

Page 8Periodic Reminder Messages (Press the “Mode” button to reset a displayed reminder.*)Message ** Frequency *** Action RequiredEvery 7 days Test an

BlowerJets 1Jets 1 Jets 2 LightLightBlowerJets 1Jets 1 Jets 2Jets 1 Jets 2Jets 1 Jets 2Jets 1Jets 1Jets 2Jets 2BlowerBlowerPage 9Jets 3, Jets 4 (opt

P/N 40569-99_C 04/26/2007Warning! Shock Hazard! No User Serviceable Parts.Do not attempt service of this control system. Contact your dealer or serv

EL/GL SERIES (Mach 3) CONTROL WITH ML550 PANELThe ML550 panel can be used with the EL8000, EL5000, EL2000 and EL1000 systems. This user guide lists al

Temp Set (80°F - 104°F / 26.0°C - 40.0°C)The last measured temperature is constantly displayed on the LCD. Your spa’s set temperature range may vary f

Preset Filter CyclesOn all systems, the pump and the ozone generator will run during filtration. At the start of each filter cycle, the blower will ru

Displaying Information About Your SpaThere are several pieces of information about your spa that can be called up from the panel, but are only needed

Page 5GFCI ProtectionYour spa may be equipped with a GFCI Protection feature. If your spa does have this feature enabled, the GFCI Trip Test must occu

Diagnostic MessagesMessage MeaningNo message on display.Power has been cut off to the spa.“Overheat” - The spa has shut down.1 On some systems, an ala

Diagnostic Messages (continued)Message MeaningTemperature unknown.Temperature not current in Economy or Sleep mode.Standby Mode has been activated by